Page 1 of 1
automechanic help
Posted: October 22nd, 2007, 5:27 am
by Full Quiver
My van is not getting fire. I have replaced plugs, wires, dist. cap and rotor, the coil, and the ignition module was tested and is good. The solenoid and starter are new & battery is good as well. What's left? The distributor itself? Can I replace the pick-up coil without replacing the distributor assembly? Are either hard to replace. 1994 Ford E350 HD ClubWagon. Low mileage, runs great (usually), and plenty of room for the family. Help please!
Posted: October 22nd, 2007, 6:27 am
by TW
Have the onboard computer checked.
TW
Posted: October 22nd, 2007, 11:17 am
by stevenson
How do you know that spark is the problem and not gas?
Posted: October 22nd, 2007, 11:56 am
by Ilovebigcats
stevenson wrote:How do you know that spark is the problem and not gas?
The famous screw driver test on the spark plug.
No sparks at all.
Posted: October 22nd, 2007, 12:39 pm
by stevenson
Well, my dad taught automechanics at one time and that would have been his first question. If you've replced the ignition coil then the next step is to replace the distributor. Happy hunting!
Posted: October 22nd, 2007, 1:02 pm
by rough_rider
TW wrote:Have the onboard computer checked.
TW
I have a Town&Country and the problem was the computer...