Jude 2

Installing my first VGA Switch/Scaler

Kramer VP-729.

Computers monitor resolution is

Primary 1600x900
secondary is 1280x800

We have two projectors one for Front of House
and one for Confidence in the rear.

FOH projector is a Mitsubishi 6700 1366x800
Rear Projector (confidence) is a Mitsubishi 3300 1280x800

Scaler output resolution is 1280x800

But when projecting Image using EasyWorship 2009
some of the text is cut off on FOH projector.

Have bypassed the switcher and still getting text issues on FOH projector.

Looks okay on secondary monitor and Rear Projector.

Suggestions.

manual set reduced res on the main projector. the system appears to need same resolutions for comparable switching.

Billy n NC wrote:Installing my first VGA Switch/Scaler

Kramer VP-729.

Computers monitor resolution is

Primary 1600x900
secondary is 1280x800

We have two projectors one for Front of House
and one for Confidence in the rear.

FOH projector is a Mitsubishi 6700 1366x800
Rear Projector (confidence) is a Mitsubishi 3300 1280x800

Scaler output resolution is 1280x800

But when projecting Image using EasyWorship 2009
some of the text is cut off on FOH projector.

Have bypassed the switcher and still getting text issues on FOH projector.

Looks okay on secondary monitor and Rear Projector.

Suggestions.

Easy to fix...... go back to the blue book

Recheck you connection for the switcher/scaler it would seem it's not working. Check manual setup.

Thanks for the input. Bypassed the switcher.

Set the 2nd monitor output to match projector.

will figure out switcher this week.

A great day.